10
www.saunacore.com
S
TEAMCORE
Automatic Rinse and Flush Operation
(Silver and Gold Models Only)
This automatic function considerably reduces the buildup of calcium
carbonate and other deposits in the water reservoir. Do not switch off any
switches between the main supply and the steam generator until at least
60 minutes after the control panel timer has turned the system off,
otherwise, the automatic emptying and flushing of the water
reservior will not start.
WARNING: The water is very hot.
Drainage from Steam Generator
The pipe must lead directly to the nearest drain outside the steam room
itself. The temperature of the water that is drained off is approximately
95°C/200°F.
IMPORTANT!
There must be no blockage of any type (tap, faucet, etc.) along
the drainage pipe. Regardless of where the drainage head is located, it
must slope all the way from the steam generator to the waste outlet. Under
certain conditions, it may be necessary to place the steam generator on the
wall brackets or a stand to achieve the right angle
.
Cleaning the Steam Room
Rinse seats and flooring with warm water (do not use a high-pressure hose)
each time the steam room has been used. Wash the seats regularly with a
mild soapy solution. Stubborn stains can be removed with ethanol or
petrolem (mineral) spirits. Never use scouring powder, strong alkaline
cleaners or aggressive solvents on the seats and walls in the steam room. It
is important that the steam room floor is cleaned thoroughly - right into the
corners. Scrub Clean with ho
t
water and floor cleaner, which will remove
grease and grime.
Shower in the steam room
We always recommend installing a shower in domestic steam rooms. After
all, a steam room also makes the best shower room imaginable. And it is so
pleasent to cool off with an ivigorating shower now and again during a
steam bath.
General Installation Instructions
(All Steam Bath Units)
Summary of Contents for KWS 10.5
Page 25: ...s ight s Page 25...
Page 26: ...Page 26...
