Ö
ØÒ
ª:
Prologue
Users instruction
Î
´
°
´
±
¾
Ê
Ö
²
á
Ö
¸
Ò
ý
°
²
×
°
Ê
¹
Ó
Ã
µ
¼
Ö
Â
µ
Ä
Ò
â
Í
â
£
¬
±
¾
¹
«
Ë
¾
¸
Å
²
»
¸
º
Ô
ð
¡
£
Ó
Ã
»
§
Ð
ë
Ö
ª
¾
¯¸
æ:
Caution:
We are not responsible for the malfunction and damage from
installation that
does
not comply to the
user manual.
1.
Make sure the model and the accessories are correct,includ
ing
the voltage imput.
2.
Make sure the steam power are matched with the s
team
room dimension.
Pay much
attention to the steam room's cubage and construction.If you have any problem,please
refer to the Page 11 about the dimension selection.
3.
Make sure to read this
in
manual detail
.
4.
We shall not be responsible for the product damage or malfunction caused by self-
installation.
5.
Steamcore
Spa II series are packged
in
a
box
,please check the goods when it
arrives to assure it is in good conditon, if you find any damage in the pack
a
ge,please
co
nta
ct the transportation company
to
file a
claim for compensation.
6.
This product must be used indoor
s
.
Some locations recommended
for
installation.
1.
The distance to the steam room less than
20ft
, the standard
cable
which link the
controller and the steam generator
22ft
.
2.
The steam generator should not be installed in the steamroom
3.
Do n
ot insta
l
l ou
t
door
s
or in any places that will influence the security of the machine
by the environment.
4.
Do not install
a
frigid loft or any plac
e
water will freeze.
5.
Do not install it near burnable and
combustible
.
objects or chemicals
6.
Install in a dry place and make adequate ventilation.
Page 1
Important:
Choosing a right location
Install an exhaust fan outside of the steam room
so
it can expel
the excessive steam from the shower room.
User Manual
Certified to CAN/CSA Std. No. 88
Conforms to UL. Std. 499
THIS UNIT MUST BE COMPLETELY INSTALLED WITH UNIONS TO ALLOW EASY REMOVAL IF FUTURE SERVICE IS NEEDED.
NOTE: Use teflon tape on the water intake solenoid and the drain solenoid to create a tight seal between the threads.
Absolutely do NOT apply heat to the plastic solenoids (water intake & drain) during installation.
It is strongly recommended that the water intake solenoid be connected to a water supply using a braided hose line.
Teflon tape is required to make a liquid tight seal between the threads and a rubber gasket (washer) is used to seal
between the solenoid and the braided hose attachment. Incorporate thread sealant (teflon tape) on both the water intake
and drain solenoid for a tight seal to avoid leaks.
Technical Hotline 905-951-6662
Summary of Contents for Xtreme Steam Tech Steamcore Spa II
Page 30: ... s ight s Page 28 ...
Page 31: ... ...
