SVR-5200S Quick Reference Guide | 009-2007-02
2 of 2
45 Perseverance Way, Hyannis, MA 02601
Copyright © 2022 Savant Systems, Inc. | 220125
Chassis Installation
CAUTION!
Ventilation for the SVR-5200S is provided by air entering through
the gap around the bottom cover and then exiting through the vent
at the rear of the host. Ensure that when the SVR-5200S is placed
there are no obstructions to the airflow around the bottom cover or
rear of the host.
Rack Installation
The SVR-5200S can be rack mounted using the RCK-3000-xx
(purchased separately) which provides easy access to the SVR-5200S
via a removable faceplate and sliding shelf. The open shelf design
provides proper ventilation and easy access to wiring.
Network Requirements
Savant requires the use of commercial grade network equipment
throughout the network to ensure the reliability of communication
between devices. Connect all Savant devices to the same local
area network (LAN) or subnet as the host. Savant recommends
not implementing any type of traffic or packet shaping in your
network topology for the Savant devices as this may interfere with
performance
IMPORTANT!
Use of the Host Wi-Fi connection may result in control or
connectivity issues.
Network Configuration
To ensure that the IP Address will not change due to a power outage,
Savant recommends using DHCP reservation within the router. By
using this method, static IP Addresses for all devices can be managed
from a single UI, avoiding the need to access devices individually.
Setting DHCP reservation varies from router to router. Refer to the
documentation for the router to configure DHCP reservation.
Network Changes
After connecting to a new network, changing routers, or if the IP
Address range is changed in the current router, Savant recommends
the following steps. This will reset any IP connection and ensure that
the host is communicating with the network correctly.
Hot Plug the Ethernet (LAN) Connection
1. Disconnect the Ethernet (LAN) connection from the host.
2. Wait 15 seconds and then reconnect.
Precautions
SURGE PROTECTION!
Use a surge-protected circuit for all components and power
supplies requiring 120-240V AC 50/60 Hz source power.
ELECTRICAL DISCONNECT!
The 120-240V AC 50/60 Hz source power outlet and input power
sockets should be easily accessible in the event of an electrical
hazard or malfunction condition.
Power Management Recommendations
Savant recommends a pure sine wave uninterruptible power supply
(UPS) with the ability to shut down the SVR-5200S before the battery
runs out of power. Never remove power from the SVR-5200S before
shutting it down.
Additional Documentation
For additional information, refer to the following documents on the
–
Savant Pro Host (da Vinci 8.9.2) - Deployment Guide - 009-1776-xx
