Savant Lamp Control Deployment Guide
Copyright © 2016 Savant Systems, LLC
009-1388-01 | 160810
10
of
38
5.3
Provisioning Steps – SmartConnect
Provisioning the Lamp Control using the SmartConnect application (v1.5 or higher) is described below.
1.
section above for initial setup and testing information. If the Lamp Control
is already set up, skip that section and proceed to step 2 below.
2.
By default, a new Lamp Control is set at the factory to be in Access Point Provisioning Mode. See
. If it is, skip this step and proceed to step 3 below. If the Lamp Control is in
some other state than Access Point Provisioning Mode follow the bulleted steps below to set it to
this mode.
•
Insert a pointed object such as a paper clip into
the reset button pinhole. Press and hold the
reset button for five seconds until LED blinks
red, then release.
•
After the reset, the LED will switch to solid
yellow while the Lamp Controller boots.
•
After approximately 5-10 seconds, the LED on
the side of the Lamp Control starts blinking
yellow once per second indicating it is in Access
Point Provisioning Mode and ready to be
provisioned to the local network.
section for LED state info.
3.
On the iOS device (iPad®, iPhone® etc.), open the SmartConnect Application
.
4.
Locate the Lamp Control in the
Devices on Bluetooth
section of SmartConnect.
5.
Tap the Lamp Control from the Devices on Bluetooth dialog window.
TIP!
If there are multiple Lamp Controls offered in
SmartConnect and the UID of the Lamp Control is
unknown, SmartConnect can be used to locate
the Lamp Control. To do this, tap one of the
Lamp Control devices offered under the Devices
on Bluetooth heading. The Status LED on the side
of the Lamp Control device will begin to blink
rapidly (yellow) for 5-7 seconds and if there is a
lamp connected, the lamp will flash 5-7 times with
the LED. If this is not the intended Lamp Control,
tap Cancel in the Pick a Network window that
opens. Continue till the Lamp Control you would
like to provision is located.
6.
In the
Pick a Network
dialog window that opens, tap the
Join Other Network…
selection (image not
shown).
7.
In the
Other Network
dialog window that opens (shown below), enter the following:
Name
– Enter SSID of the network.
Security
- Tap
Choose
in the Security field and
select the security configured in the local network.
Password
- Enter Password to the local network
TIP!
Tap the
Use Current Network SSID
field to
auto populate the Name field with the SSID
of the local network.
8.
Tap
Join
when complete.
