Savant Lamp Control Deployment Guide
Copyright © 2016 Savant Systems, LLC
009-1388-01 | 160810
21
of
38
7.9
Unbind Process
There are some scenarios such as when a Host or Lamp Control is being replaced; the Lamp Control
needs to be unbound from the configuration running on the Host before binding the new Lamp Control
device.
1.
Connect the iOS device to the wireless network that the Savant Control system is utilizing.
2.
Open the SmartConnect application
.
3.
Locate the Smart or Pro Host (Savant ID) from the list of devices under the
Devices on WiFi
section.
Tap the Host Controller to open the devices page.
4.
In the Devices page that opens, tap the
Lamp Control
to open the Device Control page.
5.
Tap the
Device Binding
tab on this page.
6.
In the Device Binding page that opens, tap
Unbind
.
7.
An
Unbind Keypad?
window will open. Read the dialog and tap
Unbind Device
if OK to unbind.
8.
The Lamp Control will no longer be bound to the Host and a new Lamp Control can be added.
