USAI RECESS PINHOLE
SERVICE INSTRUCTIONS
CAUTION READ BEFORE INSTALLATION
• Retain these instructions for future reference. This product must be installed by a person familiar with the
construction and operation of the product and the hazards involved, in accordance with applicable NEC code.
• Switch off main power before beginning installation.
• Install per national installation and accident prevention regulations.
• Clearance between sides of luminaire and parts of building to be 1/2 inch minimum; clearance to insulating
materials to be 3 inch minimum, unless luminaire is IC rated.
• Fixtures must be installed in applications where the ambient temperature does not exceed 40o C during
normal operation.
• DO NOT connect or disconnect LED board wire connector when the fi xture is energized. This may result in
permanent damage to the LED array.
• Warranty claims will not be accepted if incorrect driver or light engine is used.
Page 4
REFLECTOR REPLACEMENT FOR WALL WASH:
Caution: Power Must Be Off
1. Remove trim from housing.
2. Loosen thumb screws (2X).
3. Remove reflector by pulling.
4. Install reflector by aligning to reflector holder and pushing into place.
5. Install heatsink assembly and secure with thumb screws (2X).
6. Make sure reflector is flush with lens.
7. Install trim into housing.
Thumb
Screw
Heatsink
Assembly
Reflector
LIGHT ENGINE REPLACEMENT FOR WALL WASH:
Caution: Power Must Be Off
1. Loosen thumb screw (2X)
2. Lift and rotate heatsink assembly.
3. Remove reflector.
4. Remove cover mounting screws.
5. Remove cover.
6. Disconnect Light Engine.
7. Remove Reflector-holder mounting screws (3x).
8. Remove reflector-holder.
9. Replace Light Engine.
10. Install remaining parts in reverse order.
Reflector Holder
Heatsink
Assembly
Light Engine
Reflector Holder
Mounting Screws
(3X)
Cover
Reflector
Cover Mounting
Screws (3X)
LENS REPLACEMENT FOR WALL WASH:
Caution: Power Must Be Off
1. Remove trim from housing.
2. Remove thumb screws (2X).
3. Remove heatsink assembly.
4. Remove mounting screw.
5. Remove mounting clip.
6. Replace lens.
7. Install mounting clip and secure with mounting screw.
8. Install heatsink assembly and secure with thumb screws (2X).
9. Make sure reflector is flush with glass.
10. Install trim into housing.
Thumb
Screw
Thumb
Screw
Heatsink
Assembly
Mounting Screw
Mounting Clip
Lens
Microfusion
Side Down
© 2018. USAI, LLC.
All rights reserved.
All designs protected by copyright.
Covered by US Patents. Patents pending.
I2-482
USAI
®
Lighting
www.savant.com
savantsupport@savant.com
1-877-SAVANT5
(1-877-728-2685)
3
2
4
5
6
3
2
2
Thumb
Screw
1
8
5
3
4
7
9
