The Video Processing Output Module, VOM-VP02H, is used to overlay
TrueCommand OSD onto the currently playing video stream. Each
card allows for connection of up to two (2) OSD video streams and
two (2) displays.
Box Contents
(1) VOM-VP02H-06
(1) HDMI Locking Cable (3 feet) (CBL-3LHDMI-xx)
(1) Quick Reference Guide (this document)
Specifications
Environmental
Environmental
Refer to the SmartMediaPro chassis specifications.
Refer to the SmartMediaPro chassis specifications.
Dimensions and Weight
Dimensions and Weight
Height
1.31 in (3.33 cm) - Faceplate
Width
5.11 in (12.98 cm) - Faceplate
Depth
6.98 in (17.73 cm) - Faceplate and Board
Weight
Shipping Weight: 1 lb (0.45 kg)
Power
Power
Power is supplied through the SmartMediaPro chassis when module is
inserted (Do not hot plug module).
Power is supplied through the SmartMediaPro chassis when module is
inserted (Do not hot plug module).
Compliance
Compliance
Safety and Emissions FCC Part 15 | CE Mark | C-Tick
RoHS
Compliant
Minimum Supported Release
Minimum Supported Release
Savant OS
da Vinci 5.2.1
Rear Panel
Graphics
Input 1 and 2
19-pin type A HDMI female digital video/audio
input
Connect to HDMI or Thunderbolt (with
adapter) on Pro Host for TrueCommand OSD.
HDMI 1 and 2
19-pin type A HDMI female digital video/audio
input
Connect to display for TrueCommand OSD
overlay.
Module
Removal Slot
Insert the module removal tool (included with
chassis) into this slot and pull outwards to
remove the module.
Retaining
screws
M3 x 6 mm Phillips head flush mount screws,
Pre-installed in chassis.
Used to fasten the module to the chassis.
IMPORTANT! Module Installation Precautions
ELECTRIC DISCONNECT!
Power O
ff
the controller by setting the power switch on the rear of
the chassis to O
ff
(O)
and remove the power cord before inserting
or removing any module from the SmartMediaPro chassis. Failure
to do so may cause damage to the equipment.
IMPORTANT!
Electrostatic Discharge (ESD) Warning:
Observe the following precautions to avoid damage from electrostatic
discharge (ESD) when handling modules.
•
Use an approved ESD wrist or ankle-grounding strap. Ensure the
grounding strap makes good skin contact.
•
Connect the clip end of the ground strap to a threaded grounding
stud on the chassis.
•
When returning a replaced module to Savant, place the module in the
clamshell package in which it was originally shipped in or a static
shielding bag.
NOTE:
The wrist strap only protects the component from ESD voltages on the
body; ESD voltages on clothing can still cause damage.
VOM-VP02H-06 | 009-0410-02 | 150306
VOM-VP02H-06 | 009-0410-02 | 150306
45 Perseverance Way, Hyannis, MA 02601
Copyright © 2015 Savant Systems, LLC
1 of 2
Video Processing Output Module VOM-VP02H
Quick Reference Guide
For Product Info
