RSU2 User Guide
Savari Inc., Confidential
Copyright © Savari, Inc, 2017
5
StreetWAVE™ Getting Started Using the CLI
This section describes the procedures to get the StreetWAVE™ started after installation and
power up.
5.1 Accessing
Methods
The StreetWAVE™ can be accessed from any PC or laptop using any of the following modes:
SSH
Note
: Serial port access is not available in StreetWAVE™.
1. To Access using SSH
ssh root@ <Default IP Address> -p<port number>
port number is 51012
Password: As given in the
Default Configuration (CLI)
section.
5.2
Default Configuration (CLI)
The StreetWAVE™ has the following default configuration:
Username:
root
Password:
1[8V:2<J5*W;2I16H1nu
Ethernet (eth0)
Default IPv4 Address:
192.168.100.1
DSRC radio 1 (
Radio 1
)
: This radio is configured in channel switching mode with IPv6 support
on service channel 174 and WSAs (with WRAs) on control channel 178. WSAs announce the
same IPv6 which is configurable through CLI
DSRC radio 2 (
Radio 2
)
: This radio is configured in the continuous channel mode for channel
172.
Immediate Forward:
This application is configured to listen on UDP port *1516 for incoming
Immediate Forward text format messages from TCID over eth0 and broadcast them over DSRC
channel 172.
Firewall:
By default, only the following traffic is allowed. Rest of the traffic is blocked.
Incoming UDP over IPv6 traffic on eth0 from
FD01:1234:0186:8000::/64
destined to
StreetWAVE™ port 1516: Incoming IPv6 traffic from TCID to StreetWAVE™.
Incoming UDP over IPv4 traffic on eth0 destined to StreetWAVE™ port 51013: Incoming