13
Part No. 000820, 29-m08-2018
DELTA Owner’s Manual
Operation
1
Make sure the pendant control is plugged
into the jack on the left side wall of the
carriage body (see Figure 6). If not, open
the cap and plug in the pendant.
2
Turn on the main power switch located on
the right side wall of the carriage body (see
Figure 6). Note that when the main power
switch is turned off, you cannot run the lift
using any of the controls.
3
If the lift is not at the desired landing,
you can call the lift using the call
station controls (Figure 7 shows a call
station for an optional automatic
platform). Note that the call station
controls will only control the lift when
the platform is folded up.
4
To call the lift, first insert the key into
the call station key switch (if
equipped) and turn it on. The green
light on the call station will turn on.
5
Press and hold either the
UP
or
DOWN
button to move the lift towards you.
The green light on the call station will
flash while the lift is moving.
NOTE:
Make sure you can see the lift at all times when it is moving; stop it
immediately if there is an obstacle in the way.
6
The lift will stop automatically at the desired landing.
In the event that the lift does not stop after releasing the control button, you
can turn off the call station key switch (if equipped) to stop travel.
7
For lifts with a manual platform, lower the platform by hand. The safety arm
will rise up and the access ramp will lower automatically. Be careful of the
moving parts.
For lifts with an optional automatic platform, press and hold the
UNFOLD
button on the call station to lower the platform and raise the safety arm. The
access ramp will lower automatically.
Figure 6
POWER
PENDANT
SWITCH
JACK
DOWN
UP
Figure 7
FOLD
UNFOLD
KEY SWITCH
(OPTIONAL)
