7
Part No. 000820, 29-m08-2018
DELTA Owner’s Manual
Control Buttons
The control buttons on the pendant and the call/send stations are
constant-pressure type. This means you must press and hold the button to
operate it. Release the button to stop the function.The emergency STOP button
is push/pull.
Note that you need a key to activate the controls on the platform control panel
and at the landing call station (if the call station is equipped with a key switch).
Never use the lift if the control buttons do not work in
constant-pressure mode.
The landing call/send station controls are powered by a 9-volt battery. Under
normal operation the green light on the call station will flash when the key
switch is turned on and a control button is pressed. If the green light does not
flash, this indicates that it’s time to change the battery.
Emergency STOP Button
When you press the red
emergency STOP button on
the platform control panel
(shown in Figure 4), the lift
will stop immediately. To
release the emergency STOP
button, press and turn it
slightly clockwise.
Running Light
The red running light flashes
to indicate that the unit is in
use.
Check the emergency STOP button operation weekly. If
the lift does not stop when the button is pressed, DO NOT
use the lift. Contact your authorized dealer.
WARNING
Figure 4
Running light
Alarm button
WARNING
