5
Part No. 001132, 18-m09-2019
Orion MRL Owner’s Manual
1. GENERAL SPECIFICATIONS
Load capacity
1400 lb (635 kg)
Rated speed
30 feet per minute (0.15 m/s) nominal
Power supply
208 volt, three phase, 30 amps, 60 Hz or 240 volt, single
phase, 40 amps, 60 Hz
Lighting supply
110 volts, 60 cycle, 15 amps
Drive system
Counterweight traction with slack cable safety device
Geared motor, 1:1 sheave
Two 3/8” diameter steel cables
Rope wedge sockets
Operating temperature
-10 degrees C to +40 degrees C (+14 degrees F to +104
degrees F)
Cab sizes
42” wide x 54” deep (1067 mm x 1372 mm)
48” wide x 54” deep (1219 mm x 1372 mm)
42” wide x 60” deep (1067 mm x 1524 mm)
51” wide x 51” deep (1295 mm x 1295 mm)
Cab panel finish
Steel panel cab with optional laminates
Maximum travel
25 ft (7.6 m)
Control system
Automatic user interface; Programmable Logic
Controller (PLC)
Distance between 2
landings
18” (457 mm) minimum
Noise level (typical
installation)
68.2 dBA (up direction); 65.1 dBA (down direction)
Measured at a height equal to motor, distance of 1m, in
front of motor, no hoistway
Daily cycle
Normal: 200
Maximum starts in 1 hour on standard installation: 45
Levels serviced
Up to 6 stops
Pit depth required
14” (356 mm) minimum, 96” (2438 mm) maximum
Overhead clearance
(minimum)
108” (2743 mm) – existing building
134” (3404 mm) – new building
Control system
Single automatic push button
Floor selection
Magnetic selector
Hall station and control
panel finish
Rectangular stainless steel (standard) or brass (optional)