3
LENS CARE INSTRUCTIONS
Caution!! Read and follow these instructions EXACTLY for care and cleaning of the lenses.
Your cool new Save Phace Tactical lenses are made from the highest quality poly carbonate known
to man. BUT! IMPORTANT, PLEASE know that lenses will deteriorate, weaken and break if you
don’t clean them correctly every time you clean them. AND anti fog solutions eventually come off.
If you clean the lenses improperly, you’ll increase the rate of deterioration or possibly wipe off the
coatings. So, PLEASE follow these instructions every time you clean the lens.
1. NEVER use Windex®, 409®, Fantastic®, gasoline or anything that has alcohol or ammonia in
it to clean your lens. Most lens cleaners have ammonia or alcohol that will deteriorate the lens
coatings and/or lens material and may cause the lens to break. If your lens comes in contact with
one of these, throw it away and get a new replacement lens from us.
2. ALWAYS clean your lens every time you use it or before each game!
3. Use warm clean water and the Save Phace Micro fiber lens cloth/bag or lint free cotton cloth to
clean the lens. NEVER use paper towels, newspaper, sandpaper, etc. to clean the lens.
4. Clean the lens sealing channels on both the lens and mask. Sometimes paint will get into and
build up in these areas and may cause the lens to not seat correctly in the mask.
5. NEVER let paint or paint spray stay on the lenses overnight!
6. Single Lens Care: Take the lens out of the mask and wash with warm clean water and dry with
Save Phace Micro fiber Lens Cloth/bag.
7. Thermal Lens Care: NEVER EVER submerge the thermal lens in water. Never scrub the soft
inner lens. Never apply any type of anti fog solution to the inner lens.
8. NEVER store your Save Phace lenses or mask near chemicals or fumes.
9. NEVER store your Save Phace lenses or mask in hot places or near heat sources, for example
in the trunk of your car, in plastic bags, in direct sun light.
Always store in cool dry places. Always store the mask in a cool dry place and away from all
chemicals. Transport the mask in a protective Save Phace mask bag.
LENS INSTALLATION AND REPLACEMENT
•
IMPORTANT:
If you can pull the Lens Locking Key out of the Lens Anchor, DO NOT USE the
MASK! Replace the Lens Locking Anchor and Lens Locking Keys before you use your mask.
•
IMPORTANT:
There are 4 Parts to the Lens Locking System; 2-Lens Locking Anchors and 2 Lens
Locking Keys. Each piece is marked with and “R” and “L”.
•
IMPORTANT:
If you do not install ALL 4 Lens Locking Pieces correctly DO NOT Use the Mask.
1. Remove the Strap.
2. Insert the lens through the lens channels.
3. Press the lens firmly into the mask and install the Lens Locking Anchor that is marked “R” installed
on the Right side. And vice versa. IMPORTANT: Make sure the “R” and “L” markings on the Lens
Locking Anchor are facing toward the mask.
4. After both Anchors are in place, insert the Lens Locking Key marked with and “R” through the hole
on the Lens Anchor “R” and fully press the Lens Key through the Lens Key Channel until it is flush
against the Lens. You should feel the Lens Locking Key lock into place. IMPORTANT: Make sure
the “R” and “L” markings on the Lens Locking Keys are facing towards the inside of the mask.
STRAP REPLACEMENT
Press the strap clips together and press the strap clip toward the back of the mask.
Summary of Contents for Gen X
Page 7: ...7 NOTES ...
