Save Phace Gen X, Assembly Instructions Manual

4

MASK FIT AND CARE INSTRUCTIONS

GOGGLES MUST FIT PROPERLY AND CORRECTLY TO PROVIDE

PROTECTION!

1. Tighten the adjustable strap enough to hold the mask firmly in place. If you can shake the mask 

off, it’s too loose.

2. Make sure the foam in the inside of the goggle area seals around your face.

3. CLEAN the mask after EACH use. Failure to do so may cause the paint to stick to the mask. 

Clean the mask and foam with warm clean water and dry off with lint free towel.

4. After proper cleaning, apply ONLY Save Phace Mask Protectant to help you mask clean easier 

after a direct Paintball hit.

FOAM INSTALLATION AND CARE INSTRUCTIONS

If your Save Phace mask comes with R.W.I. (Replaceable, (hand)Washable, Interchangeable) foam 

please do not clean the foam with any detergent that could cause skin irritations.

1. To uninstall the foam, starting on one side, grab the foam support, not the foam itself, and starting 

from the top edge, gently roll the foam support up and out towards you and work your way to the 

other side until the foam support is completely off the tops of the foam base.

2. To install the foam, simply reverse the process and when you hear a SNAP, the foam and sup

-

port is secured on the foam base… PLEASE check to ensure all edges of the foam support are 

secured around the edges of the foam base.

MASK CLEANING AND STORAGE

• IF you have a Mask that has R.W.I. (Replaceable, (hand)Washable, Interchangeable) Foam, 

please remove it before cleaning.

• Remove lens before cleaning.

• Remove the strap before cleaning.

• NEVER EVER leave paint on the mask for more than 4 hours.

• After each cleaning use Save Phace Mask Protectant ONLY to protect your mask.

DO NOT remove the Black Rubber Lens Gasket! 

Clean with water only. DO NOT wear or use the 

mask if the Black Rubber Lens Gasket has been 

removed or is missing!

!

WARNING

This product meets or exceeds ASTM F1776.01 Standards for Paintball.