3K\VLFDO&RQQHFWLRQV
6DYL5)5HOD\5)5DQG5)5,QVWDOODWLRQ*XLGH
&RQQHFWLQJWKH3RZHU&DEOH
The power source can be 12 to 24 VDC, 110 VAC, or 220 VAC.
The RF Relay does not require modifications for different power
sources. An appropriate power cable is supplied, depending on
the requirements specified when the order was placed:
•
The 220 VAC cable terminates in a European connector.
•
The 110 VAC cable terminates in a North American
connector.
You can also power the RF Relay from a Savi Solar Power
Module, or by vehicle power. A fixed-length, molded cable
is supplied with the Solar Power Module. The Vehicle Power
Cable can be purchased as an accessory item.
Make sure that the antenna (with filter for the
model UDC2.4B-0C up/down converter) is
connected before you connect the power cable.
»
To connect the power cable:
1. On the bottom of the Relay NEMA enclosure, plug the
power cable’s female connector into the POWER socket
located next to the AC fuse holder. See Figure 2-5 on
page 2-8.
2. Push the locking ring forward and rotate it clockwise
until you feel resistance.
3. Then rotate the connector slightly further in the same
direction until you distinctly feel it “click” into place
as it locks.
4. Connect the other end of the power cable to an appropriate
power source, such as the Savi Solar Power Module or an
AC outlet.
Summary of Contents for RFR-100
