5HSDLUDQG0DLQWHQDQFH
6DYL5)5HOD\5)5DQG5)5,QVWDOODWLRQ*XLGH
&KDQJLQJ&KDQQHOV
Savi RF Relays have been factory configured for operation; no
settings or adjustments are required. However, it may become
necessary to change the transmit and receive channels because
of other equipment within the same area operating at the same
frequency. The RF Modem inside the RF Relay can be set to
transmit and receive at any one of 240 frequencies (channels).
Frequency codes 10–250 are assigned to these channels.
Table 3-9 on page 3-15 lists the frequency codes and their
corresponding frequency. The steps following describe how to
configure the RF Relay for operation at a different frequency.
Note:
RF Relays are preset at the factory to channel 100.
0RGHO5)52QO\
5HTXLUHG(TXLSPHQW
The following equipment is required to reconfigure channels:
•
RS-485 Adapter Cable (Savi P/N 830-00911-001 or
830-00911-002)
•
DB25M to DB9F Adapter (to connect to the PC serial port)
•
PC with a HyperTerminal program
Note:
It is not necessary to open the relay cover to change
transmit and receive frequencies for the RFR-100.
Summary of Contents for RFR-100
