The tag is shipped in sleep mode. You must remove and re-insert the
battery to wake up the tag. After you re-insert the battery, you can
initialize the tag.
Remove the battery cap.
Remove the battery.
!
"
Wait a few seconds and then reinsert the battery, matching the
negative (–) and positive (+) terminals to the symbols shown on the
tag housing. The tag will not work if you install the battery in the
wrong direction (reversed).
Summary of Contents for ST-621
