With the waterfall or stream up and running check for leaks
or areas where water may be splashing out of the system. If
necessary, backfill to raise low edges or adjust the liner to
contain splashing.
Allow the black foam 2 hours to fully cure, then fill the gravel
basin with water. Stop when you see water just below the top of
the stones in the basin.
Plug the pump cord into a protected outlet. The pump will deliver
water to the top of the waterfall and your water feature will
quickly come to life.
Finishing Up
17
Fill the Basin
Start the System
Inspect for Leaks
TIP!
Part of the fun of building a water feature is playing in
it. Spend some time tuning your water feature - use
smaller rocks to adjust both sound and flow.
S T E P 8 – F I N I S H I N G U P
