2
Warnings
Electrical Shock Hazard
•
Disconnect electrical power at the circuit breaker or fuse box before
installing this product.
•
Install this product where it will not come into contact with water or
other liquids.
•
Install this product where it will be weather protected.
•
Electrically ground this product.
•
Install this product where it will be weather protected.
•
Electrically ground this product.
Your safety and the safety of others is extremely important. Failure to follow these instructions can
result in death, fire, or electrical shock.
We have provided many important safety messages in this manual and on your product. Always read
and obey all safety messages.
Correct installation is your responsibility. Make sure you have the proper installation conditions, and
that installation conditions and installation clearances do not block air flow. Blocking air flow over the
product in any way can cause the product to overheat.
Operation Criteria
•
Pump only clean, dry air.
•
Operate at 32°F- 1O4°F (O°C- 40°C).
•
Protect unit from dirt and moisture.
•
Do not pump flammable or explosive gases or use in an atmosphere that contains such gases.
•
Protect all surrounding items from exhaust air. This exhaust air can become very hot.
•
Corrosive gases and particulate material will damage unit. Water vapor, oil-based contaminants,
or other liquids must be filtered out.
•
Consult your Distributor/ Representative before using at high altitudes.
•
This pump is oil-less and requires NO lubrication.
•
Do NOT use this product with an extension cord. Doing so will result in a void of the warranty.
•
Do NOT “hard-wire” install this product. Doing so will result in a void of the warranty.
Installation
Mounting
This product can be installed in any orientation. Mounting the product to a stable, rigid operating
surface and using shock mounts will reduce noise and vibration.
Plumbing
Remove plugs from the IN and OUT ports. Connect with pipe and fittings that are the same size or
larger than the product’s threaded ports. Be sure to connect the intake and exhaust plumbing to the
correct inlet and outlet ports.
