Warning
•
Install proper safety guards as needed.
•
Keep fingers and objects away from openings and rotating parts.
•
When provided, motor terminal covers must be in place for safe operation.
•
Product surfaces become very hot during operation, allow product surfaces to cool before
handling
•
Air stream from product may contain solid or liquid material that can result in eye or skin damage,
wear proper eye protection.
•
Wear hearing protection. Sound level from motor may exceed 70 dB(A).
•
Do not start against a vacuum or pressure load.
•
Failure to follow these instructions can result in burns, eye injury, or other serious injury.
Start Up
If motor fails to start or slows down significantly under load, shut off and disconnect from power
supply. Check that the voltage is correct for motor and that motor is turning in the proper direction.
Check the plug, cord and switch for damage. If so equipped, the thermal protection switch has
tripped, the motor can restart after cooling.
Maintenance
Disconnect electrical power supply cord before performing maintenance on this product.
If product is hard wired into system, disconnect electrical power at the circuit breaker or fuse box,
before performing maintenance on this product.
Product surfaces become very hot during operation, allow product surfaces to cool before handling-
Air stream from product may contain solid or liquid material that can result in eye or skin damage,
wear proper eye protection. Clean this product in a well-ventilated area.
It is your responsibility to:
•
Regularly inspect and make necessary repairs to product in order to maintain proper operation.
•
Make sure that pressure is released from product before starting maintenance.
Failure to follow these instructions can result in burns, eye injury, or other serious injury.
Check intake filter after first 500 hours of operation. Clean filter and determine how frequently filter
should be checked during future operation to assure the product’s performance.
1.
Disconnect electrical power supply to unit.
2.
Vent all air lines.
3.
Remove filter cover.
4.
Check filter felt. Replace felt if it is covered with contamination or shows signs of increasing
differential pressure.
5.
Re-install felt and filter cover.
4
Operation
