EN
8
8
INSTALLATION
Wall drilling and bracket fixing
11a
1
1
2
2
140
11
12a
164
164
788
540
450
140
X
1÷2
7.2.1
As a first step, proceed with the following drawings:
• a vertical line up to the ceiling or up to the upper limit, at the centre of the area in which the
hood is to be fitted;
• a horizontal line at a minimum 788 mm above the cooker top.
• Mark a point
(1)
on the horizontal line, 164 mm to the right of the vertical reference line.
• Repeat this operation on the other side, checking that the two marks are levelled.
• Mark a reference point
(2)
as indicated at 140 mm from the vertical reference line and 540
mm above the cooker top.
• Repeat this operation on the other side, checking that the two marks are levelled.
• Drill at the marked points
(1)
, using a ø 12 mm drill bit.
• Drill at the marked points
(2)
using a ø 8 mm drill bit.
• Insert the bracket plugs
11a
into the holes (
1)
and tighten the screws.
• Insert plug
11
into holes
(2)
.
To install a decorative chimney ( optional )
• Place bracket
7.2.1
on the wall, about 1-2 mm from the ceiling or from the upper limit,
aligning the centre (notch) with the vertical reference line.
• Mark the wall at the centres of the bracket holes.
• Place the bracket
7.2.1
on the wall at X mm below the first bracket (X = height of the upper
chimney section), aligning the centre (notch) with the vertical line.
• Mark the wall at the centres of the bracket holes.
• Drill ø 8 mm holes at all the marked centre points.
• Insert the wall plugs
11
in the holes.
• Fix the brackets using the
12a
screws (4,2 x 44,4) supplied with the hood.
Summary of Contents for C-6906
Page 1: ...C 6906 C 6908 Instructions Manual K ytt ohje Bruksanvisning...
Page 7: ...EN 7 7 Dimensions...
Page 18: ...FI 1 8 18 Mitat...
Page 29: ...SE 2 9 29 M tt...
