EN
1
10
FIXING THE FRAME
• Lift the frame up, making sure that the index over the
frame plate is turned forwards.
• Fit the frame slots onto the two screws inserted in the
ceiling as above, and turn until reaching the centre of the
adjustment slot.
• Tighten the two screws and fasten the other two screws
provided; before locking the screws completely, it is
possible to adjust the frame by turning it, making sure
that the screws do not come out of their housing in the
adjustment slot.
• The Frame must be securely fastened so as to support
both the weight of the Hood and the stress caused by
occasional axial pressure against the fitted Appliance.
After fixing, make sure that the base is stable even when
the Frame is subjected to lateral stress.
• If the Ceiling is not strong enough in the area where the
hood is to be fixed, the Installer must strengthen the area
using suitable plates and counterplates anchored to
resistant structures.
2
1
1
2
Connections
AIR OUTLET DUCTING VERSION
When installing the Ducting version, join the Hood to the
outlet duct using a rigid or flexible pipe ø150 or 120 mm,
selection of which is at the discretion of the installation
technician.
• Insert flaps
11b
on the Hood Canopy Outlet.
Connecting the ø 150 pipe
• Fasten the pipe using suitable pipe clamps. The materials
required to do so are not provided.
Connecting the ø 120 pipe
• To connect using a ø120 mm pipe, insert the reduction
Flange
9
onto the Hood Canopy Outlet.
• Fasten the pipe using suitable pipe clamps. The materials
required to do so are not provided.
• In both cases, any Activated Charcoal Filters must be
removed.
