7
9. ATTACHING THE FAN
BLADES
Caution:
Remove 5 rubber packing mounts
and discard before installation.
Step 1.
Attach the blade to the blade bracket
using the screws and fiber washers as shown
in Figure 14. Start screw into bracket. Repeat
for the two remaining screws.
Step 2.
Tighten each screw. Make sure the
blade is straight.
Step 3.
Fasten blade assembly to motor using
the screws supplied. (Fig. 14)
Figure 14
Figure 15
10. INSTALLATING THE
MOUNTING PLATE
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened
from the mounting ring, turn mounting
plate until it locks in place at the narrow
section of the key holes. Secure by
tightening the 2 screws previously
l o o s e n e d a n d t h e o n e p r e v i o u s l y
removed. (Figure 15)
Screws
Blade
Blades bracket
Screws
Fiber
washers
Mounting
plate
Mounting ring
Screws
