12. INSTALLING THE LIGHT
BULBS & GLASS SHADE
1. Install 3 x 60W candelabra bulbs
(provided). (Fig. 20)
2. Remove the decorative nut, glass cap and
metal nut from the light kit. Place glass
shade over the light kit stem, secure with
the metal nut (rubber side on the top)glass
cap and decorative nut. Do not overtighten.
Secure tightly the glass frame and
decorative nut. (Fig. 20)
3. Insert the 2 pull chain through the eyelet
in the shade and cap. (Fig. 20)
4. Restore power and your light kit is ready
for operation.
9
Figure 19
Figure 20
11. INSTALLING THE LIGHT
KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Step 1. Remove the 3 screws from the
mounting plate.
Step 2. While holding the light kit under
your fan, snap together the wire
connection plug. (Fig. 19)
Step 3. Install the light kit onto the
mountimg plate with 3 screws provided.
Be sure to tighten all screws. (Fig. 19)
Mounting plate
Connection plugs
Light kit
assembly
Screws
Light kit
Pull chain
Bulbs
Glass shade
Metal nut
Glass cap
Decorative nut
