7
Figure 13
Figure 14
Mounting ring
Mounting
plate
Screws
11. INSTALLING THE
LIGHT KIT
NOTE:
Before
starting
installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at
fuse box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
1. Remove the screws from the mounting
plate under the fan motor.
2. While holding the switch housing
under your fan, snap together the wire
connection plug. (Fig. 14)
3. Raise the light kit to the mounting plate
until the holes in light kit and mounting
plate line up. Reinsert screws to secure in
place. (Fig. 14)
Mounting
plate
Connection plugs
Light kit
Screws
10. INSTALLATING THE
MOUNTING PLATE
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
2. Place the key holes on the mounting
plate over the 2 screws previously
loosened from the mounting ring, turn
mounting plate until it locks in place at
the narrow section of the key holes.
Secure by tightening the 2 screws
previously loosened and the one
previously removed. (Fig. 13)
