8
9. ATTACHING THE FAN
BLADES
Caution:
Remove 5 rubber packing
mounts and discard before installation.
Step 1.
Attach the blade to the blade
bracket using the screws and rubber
washers as shown in Figure 17. Start screw
into bracket. Repeat for the two
remaining screws.
Step 2.
Tighten each screw. Make sure
the blade is straight.
Step 3.
Fasten blade assembly to motor
using the screws supplied. (Fig. 17)
Figure 18
Figure 17
10. INSTALLATING THE
MOUNTING PLATE
Step 1.
Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
Step 2.
Place the key holes on the
mounting plate over the 2 screws
previously loosened from the mounting
ring, turn mounting plate until it locks in
place at the narrow section of the key
holes. Secure by tightening the 2 screws
p r e v i o u s l y l o o s e n e d a n d t h e o n e
previously removed. (Fig. 18)
Screws
Blade
Blade bracket
Screws
Rubber
washers
Mounting
plate
Mounting ring
Screws
