8
9. ATTACHING THE FAN
BLADES
Caution:
Remove 5 rubber packing mounts
and discard before installation.
Step 1.
Attach the blade to the blade
bracket using the screws and fiber washers
as shown in Figure 17. Start screw into
bracket. Repeat for the two remaining
screws.
Step 2.
Tighten each screw. Make sure the
blade is straight.
Step 3.
Fasten blade assembly to motor
using the screws supplied. (Fig. 17)
Figure 17
Figure 18
Screws
Blade
Blades bracket
Screws
Fiber
washers
10. INSTALLING THE LIGHT
KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Step 1.
Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
Step 2.
Raise and hold the light kit close to
the ceiling fan and connect the connection
plugs from the light kit and fan. (Fig. 18)
Step 3.
Place the key holes on the light kit
over the 2 screws previously loosened
from the mounting ring, turn light kit until
it locks in place at the narrow section of the
key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Fig. 18)
Mounting ring
Connection plugs
Light kit
assembly
Screws
