9
Figure 18
Figure 19
12. INSTALLATING THE
MOUNTING PLATE
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
2. Place the key holes on the mounting
plate over the 2 screws previously
loosened from the mounting ring, turn
mounting plate until it locks in place at the
narrow section of the key holes. Secure by
tightening the 2 screws previously
loosened and the one previously removed.
(Fig. 18)
Screws
Mounting ring
Mounting
plate
Mounting
plate
Light kit
Connection plugs
Screws
13. INSTALLING THE LIGHT
KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Step 1.
Loosen the one of three screws
from the mounting plate.
Step 2.
Raise and hold the light kit close to
the mounting plate and proceed to do the
wire connections. Connect the white wire
connectors from the light kit and fan,
follow the same procedure with the black
wire connectors. (Fig. 19)
Step 3.
Tuck connections neatly into light
plate, Place the light plate key holes over
the 3 screws previously loosened from the
mounting ring, turn light kit until it locks in
place at the narrow section of the key
holes. Secure by tightening the 3 screws
previously loosened. (Fig. 19)
