7
9. ATTACHING THE FAN
BLADES
Caution:
Remove the screws from the
motor support plate, discard the screws
and motor support plate.
Step 1
Attach the blade to the blade
bracket using the screws and rubber
washers as shown in Figure 14. Start
screw into bracket. Repeat for the two
remaining screws.
Step 2
Tighten each screw. Make sure the
blade is straight.
Step 3
Fasten blade assembly to motor
using the screws supplied. (Fig. 14)
Figure 14
Figure 15
10. INSTALLATING THE
MOUNTING PLATE
1 . R e m o v e t h e 1 o f 3 s c r e w s f r o m t h e
mounting ring and loosen the other 2
screws. (Do not remove)
2. Place the key holes on the mounting
p l a t e o v e r t h e 2 s c r e w s p r e v i o u s l y
l o o s e n e d f r o m t h e m o u n t i n g r i n g ,
turn mounting plate until it locks in
place at the narrow section of the key
h o l e s . S e c u r e b y t i g h t e n i n g t h e 2
screws previously loosened and the
one previously removed. (Figure 15)
Screws
Screws
Blade
Blade bracket
Rubber
washers
Screws
Mounting plate
Mounting ring
Screws
Motor support
plate
