7 Maintenance of
7. 1 Cl eaning interior and door
Always disconnect the refrigerator from the power source before
you clean or service it.
•
Clean the interior with a cloth moistened with warm water and
wipe again with a dry cloth.
•
Clean the door of the refrigerator with a wet cloth.
•
Clean the interior condenser to remove dirt (dust etc.) at regular
intervals.
CD
NOTICE
:
Never use a brush, powder soap, cleanser, acid,
benzene, gasoline, or mineral thinners to clean the refrigerator, as
these tend to leave scratches on the plastic coating and painting.
7.2 Def rosting
Oue to the humidity within the cabinet, frost will form on the
evaporator surface after it has been used for a while.
Frost with as thick as 6mm or more ( 1 /4in) will reduce cooling
efficiency. To avoid this, the evaporator needs to be defrosted
regularly.
To defrost, turn off and unplug the refrigerator to allow for complete
removal of frost from the evaporator.
7. 3 Caution about f use and replacement
The cigarette lighter plug of the OC cord has a special thermal
fuse inside which cuts off current during abnormal situations, e.g.
overheated plug.
1 ) Remove the cover on the tip of the OC cord plug by turning it
counterclockwise.
2) When removing the cover, also remove the head terminal and the
fuse.
3) Pull out the fuse from the head terminal.
4) Replaced the fuse with a new one after making sure that its
polarity direction is correct (fig.5). Always use the special thermal
fuse supplied through Engel dealer. The arrow printed on the
fuse shall point to the head terminal as shown in figure 5 below.
5) Re-assemble the OC cord plug in a reverse order of disassembly
and tighten the cover firmly.
- 1 6 -
Summary of Contents for ENGEL MD45F-CD-P
Page 31: ... MEMO 30 ...
