Setup and Installation | 70
3. Press the
[▲] or [▼] key
to display [Interface Settings], then press the [OK] key
4. Press the
[▲] or [▼] key
to display [Network], then press the [OK] key.
5. Press the
[▲] or [▼] key
to display [Machine IPV4 address], then press the
[OK] key.
6.
Press the [▲] or [▼] key to
select [Specify], then press the [OK] key.
7.
Press the [IP Add.] selection key
8.
Press the [▲] or [▼] key to change the value
of the field.
Please check with your network administrator to confirm the IP address to be set.
When pressing and holding [▲] or [▼]
, the value will increase or decrease in increments
of 10.
Please press the [
◄
]
or [►] to move to another field.
9. Complete all the fields then press the [OK] key.
10. Press the [Subnet M] selection key.
11. Perform steps 8 and 9 again for the Subnet Mask
Summary of Contents for SG1000EU
Page 1: ...Table of Contents i ...
