Sawn Craft Micro F-16 Manual
Page 1
1311101 Micro F-16 Manual.docx
1 Introduction
The contents of this manual assume the operator will have the following prerequisites:
Understanding of all appropriate safety procedures and requirements
The ability to follow written procedures and possess basic hobby building skills
1.1 Style Conventions
Below are the important style conventions that will be used throughout the guide.
Note:
Key points or hints for success will be formatted in this manner.
Warning
: Any area that poses either a physical hazard or the danger will be formatted in this manner.
Arrows inform where to click or to perform the specified operation.
Circled items inform of items of interest for the specified operation. Circled items will typically be
accompanied by text further identifying the region of interest.
1.2 Required Tools & Supplies
The list below contains all of the required tools and supplies that are required for the assembly and
tuning of this model.
Clean, flat work surface
#11 hobby knife
Straight-edge ruler
Soldering iron & solder
Heat gun
Wire cutters
Needle nose pliers
Foam-safe adhesive
Clear packing tape
200-grit Sandpaper on sanding block
