Sawn Craft Micro F-16 Manual
Page 4
1311101 Micro F-16 Manual.docx
2 Assembly Instructions
The order of assembly presented in this instruction has been tested and it is recommended that you
do not differ from them to provide the most accurate and easiest assembly possible.
2.1 Fuselage Lamination
Parts Required:
o
Fuselage Half (2 each)
o
6” 0.083” Carbon Rod
1)
Lay both fuselage halves flat on the table with the recessed slot facing up. Apply a bead of glue
around the entire perimeter of one of the fuselage halves.
2)
Press the unglued fuse half onto the glued fuse half, recessed slots facing each other, and gently
slide the parts around to spread the glue evenly.
3)
Separate the two fuse halves and insert the carbon rod into one of the recessed slots.
4)
Rejoin the two fuse halves, glue side toward each other, ensuring that the carbon rod already in
the slot aligns with the recessed slot on the other fuse half. Set the assembled fuse lamination
aside to allow the glue to cure. If desired you can place a flat weight (book, etc.) on top of the
lamination while curing to ensure a flat assembly.
5)
Once cured, sand leading edges to your liking.
