Sawn
Craft
Mana
‐
Tee
Manual
Page
7
160121
Mini
4
‐
Fitt
Manual.docx
•
Tools
Required:
o
Beacon
Foam
‐
Tac
o
200
‐
grit
Sandpaper
2.4 Carbon Spar & KF Step Installation
•
Parts
Required:
o
Main
Wing
Assembly
o
KF
Step
Assembly
o
12”
Carbon
Spar
o
2x
Plywood
Control
Horns
1)
Lay
the
Main
Wing
Assembly
on
the
table
facing
up.
Apply
a
bead
of
glue
the
entire
length
of
the
carbon
spar
recess
in
the
wing.
Place
the
carbon
spar
into
the
recess,
ensuring
that
it
seats
evenly
in
the
slot
and
has
adequate
glue
to
secure
it.
Allow
the
glue
to
cure
for
a
few
minutes
before
proceeding.
2)
Decide
which
side
of
the
KF
Step
Assembly
will
be
faced
down
and
apply
glue
around
the
entire
perimeter
of
the
part
as
well
as
a
zigzag
down
the
center.
Place
the
KF
Step
Assembly
onto
the
Main
Wing
Assembly,
ensuring
to
line
up
all
edges.
Allow
the
glue
to
cure
for
a
few
minutes
before
proceeding.
Glue
the
control
horns
into
their
respective
slots
at
this
time.
3)
Use
the
sandpaper
to
gently
round
both
sides
of
the
leading
edge
of
the
new
assembly
to
your
liking.
This
is
an
ideal
time
to
decorate
the
parts
as
they
are
still
flat
and
will
be
easier
to
handle.
We
recommend
using
colored
packing
tape
as
it
will
add
strength
and
durability
as
well
as
vivid
color.
See
Section
3.5
for
more
detail.
