SawStop 10” Contractor Saw 17
Assembling Y
our
Saw
4. Attach one of the side panels marked D between the
front and rear portions of the stand (see Fig. 4). Make
sure the legs are in front of the side panel and that the
side panel is under the top flanges of the front and rear
panels. Bumps on the legs fit into holes in the side panel
to align the legs. Use four M8 x 20 carriage bolts, four M8
washers, four M8 lock washers, and four M8 hex nuts to
attach the side panel to the front and rear portions. Do
not fully tighten the nuts.
Assembling Your Saw
5. Repeat the prior step to attach the remaining side panel
marked D to the opposite side of the stand (see Fig. 5).
6. Attach one of the short brackets marked E between the two
front legs (see Fig. 6). Make sure the legs are in front of the
bracket. Use two M8 x 20 carriage bolts, two M8 washers,
two M8 lock washers, and two M8 hex nuts. Do not fully
tighten the nuts. Repeat this process to attach the remaining
short bracket E between the rear legs.
1
2
3
4
D
Fig. 4
4
3
2
1
D
Fig. 5
Fig. 6
1
2
4
3
E
