40 SawStop 10” Contractor Saw
Preparing Your Saw for Use
Now install the new power cord in the
contactor box. Connect the ground wire
(the green wire) to the ground, the white
wire to the right, top terminal connection
on the contactor, and the black wire to
the left, top terminal connection on the
contactor (see Fig. 45). A wiring diagram
is shown in Fig. 46.
Using a Phillips screwdriver, remove the
left screw that attaches the bar across
the cords entering the contactor box and
loosen the right screw. Then rotate the
bar downwards far enough to remove
the power cord (see Fig. 44).
contactor
thermal
circuit
breaker
power
cable
ground
power cord
Green
Green
White
White
T1
T2
L1
L2
A2
COIL
THERMAL CIRCUIT
BREAKER
MOTOR
CABLE
POWER
CABLE
CONTACTOR BOX
SWITCH BOX
CABLE
A1
COIL
CONTACTOR
White
Black
Black
Red
Black
GROUND
230V Contactor Box Wiring Diagram:
Fig. 44
Fig. 45
Fig. 46
