44 SawStop 10” Contractor Saw
WARNING!
Always turn off the main power switch
and unplug the power cord before performing
adjustments or maintenance to the saw.
Green LED blinks fast
Green LED blinks slowly
Green LED is on solid
Red LED blinks fast
Red LED blinks slowly
Red LED is on solid
Using Your Saw
Symbol Key
System Status Codes
In the event the safety system detects an error, the LEDs on the switch box will display a status code to indicate
what error has been detected. Figure 52 shows the different possible status codes which can be displayed. A
description of each status code and the necessary corrective action is provided on the following pages.
System Initializing
— this code indicates that the system is performing self-checks and energizing the brake
system to activate in the case of an accident. This condition should clear within 15 seconds after the main
power switch is turned on. If the ambient temperature is very low (below about 0º F), this code may take longer
to clear. The safety system detects such low temperatures within the brake cartridge. If necessary, the system
turns on a heater inside the cartridge to raise the temperature of the electronics. This code will continue until
the temperature inside the brake cartridge is within the normal operating range.
System Ready
— this code indicates that all self-checks have been completed, the safety system is operating
properly, and the saw is in Standby Mode ready to run.
SawStop
System Status Codes
Status
Red
Grn
¯ ¯ ¯
System Initializing
System Ready
Replace Cartridge
Coasting Down
Bypass Mode On
Push Start/Stop
Paddle To OFF
Turn Cartridge
Key To ON
No Blade Rotation
See Manual
Adjust Position of
Brake Cartridge
Contact Detected
During Standby
Contact Detected
During Bypass
Overload Due To
Wet Wood
• • • • • •
¯ ¯ ¯
¯ ¯ ¯
• • • • • •
¯ ¯ ¯
• • • • • •
• • • • • •
• • • • • •
• • • • • •
¯ ¯ ¯
• • • • • •
Fig. 52
