66 SawStop 10” Contractor Saw
Adjusting the Tilt Limit Stops and Tilt Angle Indicator
The tilt limit stops allow you to easily and quickly set the bevel angle to 0° and 45°. However, when making
precision cuts, it is always best to check the angle of the blade with a combination square or similar tool.
Making Adjustments to Your Saw
0° Tilt Limit Stop
To check the position of the 0° limit stop,
install a 10 inch saw blade on the arbor
(see page 29). Raise the blade to its full
elevation, and turn the tilt handwheel
counter-clockwise until the limit stop is
reached. Using a square, check to see
that the blade is at a 90° angle to the
table (see Fig. 86). If you need to adjust
the position of the 0° limit stop follow the
instructions below.
The 0° tilt limit stop is
determined by the set screw in
the cast iron table top located
to the left of the front of the
table opening. (see Fig. 87).
Use the included 3 mm hex
key to turn the screw counter-
clockwise several turns.
Next, adjust the tilt handwheel
until the blade is at 90° to
the table. Turn the 0° limit
set screw clockwise until it
is tight. The 0° limit stop has
now been set.
WARNING!
Always turn off the main power switch and unplug
the power cord before making any adjustments to your saw.
Fig. 86
Fig. 87
0° tilt
limit stop
45° tilt
limit stop
