SawStop
®
10” Industrial Cabinet Saw 61
Adjusting
Your
Saw
Making Adjustments to Your Saw
The head of the bolt is painted yellow for easy
identification. To adjust the position of the 45° limit
bolt, first loosen the locking nut and back it off
several turns. Next, turn the 45° limit bolt clockwise
to increase the angle of the limit stop, or counter-
clockwise to decrease the angle of the limit stop.
Now turn the tilt hand wheel clockwise until the limit
stop is reached. Recheck the angle of the blade
relative to the table. If further adjustment is needed,
decrease the tilt angle to about 30° and readjust the
45° limit bolt. Repeat this process until the blade is at
45° to the table when the limit stop is engaged.
Once the 45° limit bolt is properly adjusted, turn the
locking nut clockwise until it is tight. The 45° limit
stop has now been set.
6. Adjusting the Table Insert:
The SawStop zero clearance insert has been designed to fit securely within the table opening and just below
the table top. The insert is pre-cut at the factory with a 10 inch blade after all alignments to the saw have been
completed.
As shown in Fig. 75, the insert includes front and rear leveling screws to set the height of the insert. In addition,
positioning screws at the rear and right side of the insert prevent it from rattling in the table opening. Finally, a
lock-down lever at the front of the insert prevents the insert from rising up unexpectedly.
The insert should slide easily into
and out of the table opening, but
should not be loose in the opening.
If the insert is too loose, use the 3
mm hex L-wrench to turn the side
and/or front positioning screw(s)
counter-clockwise as needed to
reduce the clearance between
the insert and the table opening. If
the insert is too tight, turn the side
and/or front positioning screw(s)
clockwise as needed to increase
the clearance between the insert
and the table opening.
Fig. 74
Fig. 75
45° tilt
limit stop
front leveling screws
rear leveling
screws
positioning
screws
positioning screws
lock-down
lever
WARNING!
Always turn off the Main Power Switch and switch the Disconnect
Switch to the OFF position before making any adjustments to your saw.
