18
RT-TGI OWNER’S MANUAL
9
7
8
Attach the support legs to the underside
of your router table. Place your router
table upside-down on a flat surface,
such as the floor. Find the two sets of
threaded holes near the front of the
table (indicated by the red arrows in
Figure 12). The leg brackets with the
power switch can each be installed on
either the left or right side of your table,
depending on the user’s preference.
Insert an M5 x 30 pan head Phillips screw
(3.12) through an M5 lock washer (3.9)
and an M5 washer (3.10), then through
the exposed mounting holes in the handle
mounting bracket (3.11) and leg mounting
bracket. Use a Phillips head screwdriver
to secure the screw.
Next, install the screw that is used to store
the insert wrench that comes with your
router lift. Insert an M5 x 30 pan head
Phillips screw (3.8) through an M5 lock
washer (3.9) and an M5 washer (3.10),
then all the way through the back of the
remaining small hole in the front of the leg
mounting bracket (3.7). Use a Phillips head
screwdriver to secure the screw.
3.11
3.12
3.9
3.9
3.10
3.10
3.8
3.7
3.7
