30
RT-TGI OWNER’S MANUAL
13
14
15
Adjust the feet in the support legs until
they contact the ground and keep the
cast iron table level. Then use a 13mm
wrench to tighten the M8 hex nuts (2.2)
up against the bottoms of the
support legs.
Next, mount the router table to the front
and rear rails using the hardware from
the “Rail Mounting Hardware” bag from
your Power Switch (RT-PSW) box. Insert
four M8 flat head socket screws (3.17)
through the holes in the front and rear
rails and router table. Secure the screws
with four M8 washers (3.18), four M8
lock washers (3.19), and four M8 hex
nuts (3.20). Use a 5mm hex wrench and
a 13mm wrench to tighten the hex nuts.
Follow the instructions in your table saw fence manual to reinstall the main tube
and retighten the hardware securing your front and rear rail to your table saw. See
your table saw fence manual for further information.
The hardware for the next steps can be found in the “Rail Mounting Hardware” bag from your
Power Switch (RT-PSW) box.
i
Congratulations! You have completed the In-Line Installation Right: Between 52" Rails section.
Continue to the following page for next steps.
2.2
3.17
3.18
3.19
3.20
