35
RT-TGI OWNER’S MANUAL
11
If you have a Downdraft Dust Collection Box for Router Lift (RT-DCB) installed, use
the provided dust hose and hose clamps to secure the 2 ½” dust hose to the router
table fence to the dust port splitter on the dust box. Further information can be
found in your Four Post Router Lift manual, which includes information about the
dust box as well. Copies of your manuals can be downloaded at
www.sawstop.com
. Otherwise, use a 2 ½” dust hose (not provided) and two dust
hose clamps (not provided) to attach the 2 ½” dust port on the router table fence
directly to a dust collection system.
If there is excess dust hose length between the 32” fence and the dust box, you can shorten
the dust hose.
i
When making jointer cuts, it can be
useful to offset one router fence face
plate (4.14) relative to the other router
fence face plate. Two fence face plate
space bars (4.13) are used to do this,
and they can be installed to offset
the router fence face plates by either
0.7mm or 1.5mm. It is important to
install both fence face plate space
bars facing the same direction, so they
both extend either 0.7mm or 1.5mm
beyond the edge of the fence. To install
the fence face plate space bars (4.13),
loosen the three lock knobs (4.6) on
one side of the back of the router table
fence (4.1), and slide the two fence face
plate space bars onto the two T-shaped
extensions behind the fence face plate.
Then retighten the three lock knobs to
secure the fence face plate in place.
i
4.6
4.1
4.13
4.13
