The holes in the bottom of the front rail are oversized to allow the position of the tube on the rail to be adjusted. To set the
tube in the correct position, pull the tube away from the cast-iron table as far as possible. Next, place the fence on the
tube with the fence glide bracket resting on the upper rear edge of the tube. Position the fence so that it is near the left
end of the tube and the front glide plates (10) are in contact with the rear surface of the main tube (Fig. 24).
Next, attach the fence handle to the fence by threading the handle into the cam lock (Fig. 25). Press down on the fence
handle to clamp the fence to the main tube (Fig. 26).
SawStop
Page 11
|
SawStop T-Glide Fence System - Industrial Series II
Fig. 24
Fig. 26
Fig. 25
10
