If adjustment is required, use a 5 mm hex key to turn one of the two parallelism adjustment screws (11) (Fig. 27) until
the faceplate is flush with the miter slot.
The next step is to adjust the face plates (2) to be perpendicular to the table top. The angle between the face plates
and the table is set by the two plastic leveling screws (9) on top of the glide bracket (Fig. 33).
Parallel and Perpendicular:
The next step is to align the face plates (2) to be parallel to the miter slots. Begin by
sliding the fence along the tube until the left face plate is flush with the right edge of the right miter slot. Lock the fence
handle and check that the full length of the face plate is flush with the miter slot edge (Fig. 32).
Fig. 32
Page 14
|
SawStop T-Glide Fence System - Industrial Series II
Fig. 33
2
2
9
