To install the rails, extension table, and fence you will
need the following tools:
5 mm hex driver and 5 mm hex key (included)
6 mm hex key
13 mm and two 17 mm wrenches (or adjustable wrench)
Combination square
Phillips head screwdriver
Straight edge
NOTE: To see how all the components fit together, see the exploded views located in the back of this manual. The
callout numbers in the image figures correspond with the exploded views.
Lift the right end of the rail until it’s parallel with the table and thread two more M8 x 25 countersunk socket head bolts
(6) into the other two threaded holes in the front of the main table (Fig. 3). Tighten the bolts using the 5 mm hex key.
Front Rail:
The first step to install the fence is to attach the front rail to the table. The rails are shipped in the long
cardboard box packaged with the main tube. The front rail (1) is the larger of the two and has 5 countersunk holes that
are used to mount the rail to the front of the table. To mount the rail, begin by placing the rail on the floor next to the
front of the saw. Lift the left end of the rail until the third hole from the left in the rail aligns with the center hole in the
main table. Thread an M8 x 25 countersunk socket head bolt (6) into the threaded hole. (Fig. 2) Do not fully tighten.
Next, mount the front rail to the cast iron extension wings using two M8 x 35 countersunk socket head bolts (2) (the
longer bolts), two M8 washers (3), two M8 lock washers (4) and two M8 hex nuts (5). Position the bolts through the
front rail and the extension table, then install the washer, lock washer and nut (in that order) on the end of the bolt
(Fig. 3). The holes in the extension wings are not threaded and are slightly larger than the bolts they receive. If
necessary, use the rail to pull the wings up or down slightly until the wings are flush with the table. Use a 5 mm hex
key and a 13 mm wrench to tighten the nuts, to secure the wings in place.
Installation
Page 4
|
SawStop T-Glide Fence System - Industrial Series II
Fig. 2
Fig. 3
2
1
1
2
3
3
4
4
5
5
6
6
6
6
