Rear Rail:
You install the rear rail (9) like you installed the front rail, except that you will leave the bolts for the rear rail
a little loose until you install the extension table; it may be difficult to position the extension table between the rails if
both rails are tightened too much. The rear rail is attached to the main table by two M8 x 25 (6) countersunk socket
head bolts (Fig. 4). Position the rear rail along the back of the table with the cut-outs at the top of the rail centered on
the miter gauge slots in the table. Thread the bolts into the holes and hand-tighten.
Mount the rear rail to each extension wing using two M8 x 35 (2) countersunk socket head bolts (the longer bolts), two
M8 washers (3), two M8 lock washers (4) and two M8 hex nuts (5) for each of the holes, as shown (Fig. 4).
Leg Support Brackets:
Locate the two leg support brackets (20) and align them to the underside of each rail
(Fig. 5). Insert two M8x20 countersunk socket head bolts (21) through the top of the rails. On the underside of each
bracket, place an M8 washer (14), an M8 lock washer and an M8 hex nut (16). Hand-tighten the nuts.
Once mounted, the brackets should create a shelf for the table to rest on (Fig. 6).
Fig. 4
Fig. 6
Page 5
|
SawStop T-Glide Fence System - Industrial Series II
Fig. 5
2
2
3
3
4
4
5
5
6
6
9
16
14
21
20
15
