Extension Table, 36 Inch Fence System:
The extension table mounts to rails with bolts that pass through holes in
the rails and extension table. Insert an M8 x 40 countersunk socket head bolt (17) through the holes in both the
front and rear rails, closest to the wing (Fig. 12).
Fig. 12
Supplemental Mounting Kit.
(If your extension table uses the adjustment bracket, you can skip this section.) The
supplemental mounting kit is included in the hardware bag. The extension table contains a through-hole in the center
of the left side of the frame that aligns with a matching hole in the center of the edge of the right extension wing. Place
the extension table between the rails (Fig. 10). Install the M8 x 45 socket head bolt (A) and D-washer (B) through the
hole in the extension table. (Fig. 11) The bolt should extend through the hole in the extension wing. Make sure the flat
edge of the D-washer faces upward. Install an M8 x 23 x 2 washer (C), and an M8 x 1.25 hex nut (D) on the end of
the bolt and hand-tighten, do not completely tighten at this time.
Fig. 13
Extension Table, 52 Inch Fence System:
Insert an M8 x 40 countersunk socket head bolt (17) through each of the
two holes in both the front and rear rails, closest to the wing (Fig. 13).
Place an M8 washer (14), an M8 lock washer (15) and an M8 hex nut (16) on the threaded end of each bolt. Hand-
tighten the nuts; do not fully tighten them.
Do not insert bolts through the outermost holes in the front and rear
rails at this time.
Page 7
|
SawStop T-Glide Fence System - Industrial Series II
Fig. 11
14
16
15
15
16
14
17
17
C
D
B
B
A
A
14 15 16
17
17
16 15 14
