5
TSG-FDC OWNER’S MANUAL
Attaching the Dust Collection Guard Mounting Bracket to the Extension Table
1
2
Place the flat edge of the dust
collection guard mounting bracket
(B) against the right edge of the
extension table on your saw, with
the top of the dust collection guard
mounting bracket flush or just
below flush with the top of the
extension table.
Reference the table and figure
below for accurate placement of the
bracket based on your saw model
configuration. The mounting pins on
the dust collection guard mounting
bracket (B) should align with the
center of the blade.
The elongated mounting slots in the bracket will allow for some adjustment of the positioning if
needed once it has been mounted to the extension table.
i
B
B
The distance between the mounting bracket and the rear edge of the extension table
should match the value listed for your model saw in the table above.
Bracket Mounting
Saw Extension
Table
Distance Between Bracket
and Rear of Extension Table
ICS
36”
4”
52”
4”
PCS
TGP2 36”
1 5/8”
TGP2 52”
1 5/8”
CNS
TGP2 36”
1”
TGP2 52”
1”
MOUNTING
PINS
