9
TSG-FDC OWNER’S MANUAL
Assembling the Leg Support Brackets
1
2
3
4
Insert a 1/4”-20 x 3/4” flat head
socket screw (M) through the eye
of an eye bolt (N), and then through
one of the holes in a leg support
mounting bracket (O). Then place a
1/4” lock washer (P) onto the screw,
followed by a 1/4”-20 nut (V). Only
finger-tighten the nut at this time.
Repeat this process for the other
eye bolt and leg support mounting
bracket.
Thread a 1/4”-20 nut (V) about half
way up the shaft of each eye bolt
(N).
Insert the shaft of an eye bolt (N)
through the hole in the bent end of a
leg support bracket (C), followed by
a 1/4” lock washer (P) and a 1/4”-20
nut (V). Only finger-tighten the nut at
this time.
M
N
V
N
O
P
V
V
P
N
C
