4
TSG-FDC OWNER’S MANUAL
ASSEMBLY INSTRUCTIONS
Attaching the Extension Leg to the Dust Collection Guard Mounting Bracket
PAGES:
4-19
1
2
3
Slide the hollow end (the end
without the cap) of the extension
leg (A) about 3 inches into the leg
portion of the dust collection guard
mounting bracket (B).
Adjust the overlap between the
extension leg (A) and the dust
collection guard mounting bracket
(B) until the top of the dust
collection guard mounting bracket
approximately matches the height of
your extension table.
Thread the two 1/4”-20 extension
leg lock knobs (I) into the two
nuts on the dust collection guard
mounting bracket (B). Tighten the
extension leg lock knobs evenly to
secure the extension leg.
The extension leg lock knobs should
engage the extension leg and lock
it against further movement. This
will help prevent potential injury due
to unexpected movement of the
floating dust collection guard.
The exact height is not critical at this point, as it can be adjusted after the dust collection guard
mounting bracket is attached to the extension table.
i
HEIGHT OF YOUR EXTENSION TABLE
B
B
B
A
A
I
