Double Cut Torch
Carrier Manual
Model 283B
For Quick Set Beveling
Model 205CS
Sawyer Manufacturing Company
7799 S. Regency Dr., Tulsa, OK 74131 USA
F
918.834.0318
info@sawyermfg.com
P
918.834.2550
sawyermfg.com
V1.2
DOUBLE CUT TORCH CARRIER
Tools Needed for Assembly*
9/16” Nut Drive
Warranty
All products manufactured by or for Sawyer Manufacturing Company are
guaranteed against defects due to faulty workmanship or materials for twelve
months from the date of purchase.
This guarantee is limited to the repair or replacement of any parts found to be
defective, and no other liability, expressed, implied or contingent is assumed.
We appreciate your business!
Congratulations on your new SAWYER product. We are proud to have
you as our customer and will strive to provide you with the best service
and reliability in the industry. This product is backed by our extensive
warranty and world-wide service network. To locate your nearest
distributor or service agency, please contact us at the phone number
and address listed on the bottom of each page.
You are in good company!
Sawyer Manufacturing Company is the world leader in the design and
manufacture of pipeline and welding equipment since 1948. Sawyer
equipment has become a standard in the industry and continues to set
the benchmark for quality and durability.
This user operation manual has been made to instruct you for the best
use and operation of your Sawyer product. Your satisfaction with our
products is our main goal. Please read this entire manual carefully
noting all tips, notes and warnings. Safety always comes first.
Note:
When back beveling, place torch tip as
close to the pipe as possible (recommend pinky
nail length). Do not place flame directly on pipe.
Rotate the assembly to your desired angle. Then
once you have the correct angle it should be
positioned for a back bevel.
About Us
18mm Wrench
WARNING:
Moving parts can snag
and pull. Keep loose items clear.
!
!
WARNING
WARNING:
Refer to manufacturers
settings for safety settings.
!
!
WARNING
F
A
D
C
G
B
E
1/2” Wrench
*Not Included
CAUTION:
When back beveling, the cutting flame
is directed toward the machine. It is important
the torch be positioned as far as possible to the
opposite end of the torch arm to prevent the heat
from damaging the machine warnings. Safety
always comes first.
!
!
CAUTION
Parts Diagram
*Note: Torch not included*
*Note: Quick Set machine not included*
A.
Torch Holder Adjustment Knob
B.
Position Adjustment Knob
C.
Bevel Indicator Square Nut
D.
Oxygen Hose (Green)
E
. Fuel Gas hose (Red)
F.
37.5-0-37.5 Degree/Bevel Indicator
G.
Torch Arm Assembly
H.
9/16” Nut
*not pictured*
I.
2–Washers
*not pictured*
J.
Wing Nut
*not pictured*
K.
Spacer
*not pictured*
L.
2 Threaded Bolts
*not pictured*
